Zero-gravity Kawasaki Z1000 (10-11) Windscreen Bedienungsanleitung PDF herunterladen

WWW.ZEROGRAVITY-RACING.COM

16-227 install

Rev B

Note: If the two upper fasteners are not grabbing the wellnut threads,

you will have to reach behind the two upper wellnuts and push

them against the fasteners to start the screwing process.

8. Tighten all 4 windscreen fastener screws so that the windscreen is

firmly in place. DO NOT OVER-TIGHTEN!

nstallation Instructions for Double Bubble

indscreen 2010-2013 Kawasaki Z1000

Thank you for purchasing one of Zero Gravity’s windscreens which has been designed and manufactured to give years of safe

and fun riding. This instruction manual gives you an in-depth look at the installation process. To receive further assistance or parts

please e-mail [email protected].

pacer installed

between wellnut

and screen.

Well Nut

Locations

Fasteners

Washers

pacers

Wellnuts

indscreen

1. Remove the factory wind

screen.

2. Before installing your new Zero

Gravity screen, locate the 2 spacers pro-

vided with your windscreen.

3. Place your Zero Gravity windscreen on the bike and align the wind-

screen holes with the windscreen bracket holes.

4. Insert two of the four original windscreen fastener screws and wash-

ers into the two bottom holes and screw them into the threaded re-

ceptacles a few turns into the wellnut.

5. Lift the rear edge of the screen so the screen tilts up slightly.

6. Place the spacers between the windscreen and the windscreen

bracket so they align with the upper holes of the windscreen and the

Well Nut receptacle holes of the bracket.

7. Insert the two remaining fasteners and washers into the upper wind-

screen holes so that they pass through the windscreen and spacers

and then into the threaded receptacle.

Spacer is inserted

where the circle shown

SPORTBIKE SADDLES & WINDSCREENS